SAVE UP TO 25% WITH OUR CHRISTMAS SALE* SHOP ONLINE NOW

Can I adjust the settings on my Garage Light occupancy sensor?

1st Generation Occupancy Sensor

Time Delay

To change the amount of time the light stays on when the room is unoccupied, remove the sensor’s lens, and adjust the set screw labeled “Time Delay.” The delay can be set from 30 seconds (turn screw fully counterclockwise) to 30 minutes (turn screw fully clockwise).

Light Level

To adjust the ambient light level at which the light will turn off when the space is occupied, remove the sensor’s lens, and adjust the set screw labeled “Light Level.” The light level can be set from a very dim 10 fc (foot-candles) to a very bright 120 fc. By default, the light is set to 120 fc. For most applications, we recommend leaving the light level at 120 fc.

2nd Generation Occupancy Sensor

This sensor comes preset from the factory to shut off ten minutes after the room is unoccupied. These settings can not be adjusted. If you have special circumstances where setting adjustments are required, please contact Big Ass Fans Customer Service at 1300 244 277.

This applies to these products: The Garage Light (Legacy)

Was This Helpful?

Yes
No

Still need help?

Call Email